EK1 Mini2+ 17mm Ball Mount Adapter

Description

This EK1 Mini2+ mount gives you a clean way to run your tuner display without suction cups or messy brackets. First, the EK1 Mini2+ slides into the holder for a secure fit. Next, you attach the holder to a standard 17mm ball mount, so you can place the screen exactly where you want it and keep an OEM plus look.

Why this adapter is different

• First, it fits the EK1 Mini2+ on purpose: we built the holder around the device for a secure, clean fit.
• Next, it works with standard 17mm mounts: you can use many common 17mm ball mounting systems.
• Also, you get an adjustable angle: you can quickly set the best viewing position for driving.
• Because the setup locks in place, the screen stays stable instead of bouncing around on rough roads.
• Finally, it keeps things clean: you avoid dashboard clutter and keep the cabin looking factory.

Fitment

• Device: EK1 Mini2+
• Mount interface: Standard 17mm ball
• Note: This listing includes the holder adapter only. It does not include the EK1 Mini2+ device.

What is included

• EK1 Mini2+ holder adapter with 17mm ball socket interface.
• Locking ring or collar shown in the product photos.

Install information

• Estimated install time: about 2 to 5 minutes.
• Difficulty: Easy.
• First, slide the EK1 Mini2+ into the holder until it fully seats.
• Next, press the adapter onto your 17mm ball mount.
• Then tighten the locking ring to lock your angle in place.
• Finally, double check everything before driving.

Usage notes

Mount the device in a safe location that does not block your view of the road or interfere with any airbags. Also check tightness occasionally, especially after temperature changes or rough roads. If you adjust the angle often, tighten the ring again afterward so the mount stays solid.

EK1 mount questions

Still have questions? Check out our
PLUGNPLAYCUSTOMS FAQ page.

EK1 and JB4 are third party products. PLUGNPLAYCUSTOMS is not affiliated with or endorsed by Burger Motorsports.